Sachs SA 340 - Page 31

INSTRUCTIONS AND WIRING DIAGRAM
FOR
DYNAMO MAGNETO 12 V 75 W
The dynamo mag neto generates alternating current with a lighting powe r of 75 Watt
at 12 Volt .
Only one of the yellow leads shou ld be connected up (see wiring diagram ).
The second
ye llow lighting l ead rem ain s blind and may be used lat er for connecting
up a rectifier to charge a battery .
The
bulbs should be so se lect ed that the total load of the dynamo magneto is 50 Watt .
For reaching the 75 Watt a r es ista·nce of 25 Watt must be added.
Care should be taken to ensure a good earth connection from the engine v ia the
chassis to the lamps.
,..---
,-----
1
~Xltl~----' · "Cla I"IU---T"-
i
I
I
I
I
ll
' Fig. 38
Aa = Load (12 V 50 W)
Ao = Resislance ( 12 V 25 W)
810 Ignition l ight sw itch
C Dynamo magne to
C2 Dynamo armature
( 6 I gnit ion armature
Switching positions :
0 = Off (I gnition short -c ir c uit ed)
I =
Ni g ht opera tion
II
= Day op eratio n
Il l = Intended for star tin g
Co = I gnitio n coil ( lying outside)
(, = Sparking plug
(H. = Terminal c arri er
Cn = L ighting l ead (yellow)
(,. = Additional earth l ead (bro wn)
(, = Short-circuiting l ead (black)
35