Saebo SaeboStim Pro - Powering the Device; Device On;Off Procedure

SaeboStim Pro
Clean Skin
Remove all jewelry and clean skin thoroughly with soap and water. Rinse and dry.
Electrodes do not work well if any lotion, oil, dirt is on the skin.
Plug in Electrode Wires
The Electrode Wires provided with the unit are inserted into the Output Ports (OUT
A / OUT B) located at the top of the Stimulator. The wire connectors have been
designedsotheywillinsertandconnectrmlyintoplace.IfonlyoneElectrodeWire
is needed, plug it into Outlet A. See Figures 6 & 7.
Figure 6 Figure 7
26