Saeco HD8763 - Page 79

77 ENGLISH 77
Machine actions Causes Solutions
The machine does not turn on. The machine is not connected to the
electric network, or the power but-
ton is in the “O” position.
Connect the machine to the electric
network and turn the power button to
the “I” position.
The drip tray gets  lled al-
though no water is drained.
Sometimes water is drained auto-
matically by the machine into the
drip tray to manage the rinsing of
the circuits and ensure optimum
machine performance.
This is a normal behaviour of the
machine.
The red
icon is always dis-
played on the machine.
The co ee grounds drawer has been
emptied with the machine o .
The co ee grounds drawer must al-
ways be emptied with the machine on.
Wait until the icon is displayed
before re tting the drawer.
Co ee is not hot enough. The cups are cold. Preheat the cups with hot water.
Temperature is not correctly set. Set the temperature as described in the
"Programming" chapter.
The machine circuit is clogged by
limescale.
Descale the machine.
Co ee does not have enough
crema.
(See note)
The blend is unsuitable, co ee is not
freshly roasted or the grind is too
coarse.
Change co ee blend or adjust the
grind setting as explained in the
“Adjusting the Ceramic Co ee Grinder”
chapter.
The machine takes a long time
to warm up or the amount of
water dispensed is too little.
The machine circuit is clogged by
limescale.
Descale the machine.
The brew group cannot be
removed.
The brew group is not in the right
position.
Turn on the machine. Close the service
door. The brew group automatically
returns to the initial position.
The co ee grounds drawer is
inserted.
Remove the co ee grounds drawer
before removing the brew group.
The brew group cannot be
inserted.
The brew group is not in the o
position.
Make sure that the brew group in
the o position, as described in the
“Weekly Cleaning of the Brew Group”
chapter.
The gearbox is not in the correct
position.
Insert the drip tray and the co ee
grounds drawer. Close the service door.
Turn on the machine without inserting
the brew group. The gearbox returns
to the correct position. Turn o the
machine and reinsert the brew group
as described in the “Weekly Cleaning of
the Brew Group” chapter.