13
ENGLISH
13
Yellow
Note:
By keeping the
button pressed for more than 8 seconds, the machine
enters the demo mode. To exit the demo, disconnect the power cord and
turn the machine back on.
15
The control panel indicates that the circuit must be primed.
USING THE MACHINE FOR THE FIRST TIME
When using the machine for the rst time, the following activities need to
happen:
1) You need to prime the circuit.
2) The machine will perform an automatic rinse/cleaning cycle.
3) You need to perform a manual rinse cycle.
Circuit Priming
During this process, fresh water ows through the internal circuit of the
machine and the machine warms up. This takes a few minutes.
1
Place a container under the hot water dispensing spout.
To Next Page
Loading...
