Saeco Minuto - Technical Specifications; Product Technical Details; Guarantee and Service; Guarantee Information

55 ENGLISH 55
Machine actions Causes Solutions
The machine grinds the
co ee beans but no co ee
comes out.
(See note)
There is no water. Fill the water tank and prime the
circuit (chapter “Using the machine
for the  rst time”).
The brew group is dirty. Clean the brew group ("Weekly clea-
ning fo the brew group" chapter).
The circuit is not primed. Prime the circuit (chapter “Using the
machine for the  rst time”).
This might occur when the ma-
chine is automatically adjusting
the dose.
Brew a few cups of co ee as de-
scribed in chapter "Saeco Adapting
System".
The dispensing spout is dirty. Clean the dispensing spout.
Co ee is too weak.
(See note)
This might occur when the ma-
chine is automatically adjusting
the dose.
Brew a few cups of co ee as de-
scribed in chapter "Saeco Adapting
System".
Co ee is brewed slowly.
(See note)
The co ee grind is too  ne. Change co ee blend or adjust the
grind as explained in chapter “Adju-
sting the ceramic co ee grinder”.
The circuit is not primed. Prime the circuit (chapter “Using the
machine for the  rst time”).
The brew group is dirty. Clean the brew group ("Weekly clea-
ning fo the brew group" chapter).
Co ee leaks out of the
dispensing spout.
The dispensing spout is clogged. Clean the dispensing spout and its
holes.
The milk was not frothed. The automatic milk frother has
been inserted too far. No milk is
being sucked.
Let the Automatic Milk Frother cool
down. Slightly move it downwards.
Place it back in its proper seat.
The frothed milk is too cold. The cups are cold. Preheat the cups with hot water.
Note:
These problems can be considered normal if the co ee blend has been
changed or if the machine has just been installed. In this case wait until
the machine performs a self-adjusting operation as described in chapter
“Saeco Adapting System”.