55
English
10 - INACTIVITY
If the automatic vending machine remains
inactive for a long time it is necessary to take
certain preventive measures:
- with the machine on, start the automatic
emptying process of both the hydraulic circuit
and the boiler (see PROGRAMMING AND
MAINTENANCE MENU in section 8).
- once it is over, disconnect the machine from
the power and hydraulic supply
- disassemble the closing panel on the back
of the machine.
- complete the emptying of the tank with float
by removing the hose clamp located on the
air-break device drain hose
- once the emptying is over, refit the hose
clamp (fig.64)
11 - DISMANTLING
Empty the products and water as described in
the previous section. For dismantling, it is
advisable to disassemble the machine parts
according to their composition - plastic, metal
etc. Afterwards, deliver the divided parts to the
specialised companies. If a refrigerating unit is
present, give it without disassembling it to
companies authorized for the disposal of this
particular part.
- assemble the closing panel on the back of
the machine.
- unload all products from the containers
- wash all the components that are in contact
with foodstuff as previously described
- empty the trays from dry and liquid dumps,
then clean them accurately
- clean all vending machine internal and
external surfaces with a cloth
- protect the outside of the machine with plastic
film or a bag
- store in dry, sheltered environments at a
temperature not lower than 1°C
fig.64
To Next Page
Loading...
