Then updating begins, LCD shows as:
After updating is finished successfully, LCD shows as:
Turn off PR9 and take out the special downloading board. Fit on
normal parallel board and PR9 will work normally after power on.
NOTE1:
If PC’s LPT port, which is to be transmit firmware data to PR9, already
has data in its buffer, then updating is forbidden, and please delete the
data in the LPT port: open the ‘PRINTERS AND FAX ’ window
choose the printer which has print documents select “purge print
documents” wait for a moment till print documents are canceled
successfully.
PROGRAMMING 13BB0
UPDATE O.K.
To Next Page
Loading...