Safety 1st Alpha Select - UAS Installation

31 32
UAS Installation
1. Pull Pad Off Front
Corners of Child
Restraint As Shown
Safety Tips
Make sure harness and buckle fit your child correctly before
installing the child restraint. See pages 3-4.
Experts agree that children should remain rear facing as long as
possible. In this child restraint, your child can remain rear facing up
to 18 kg (40 lb) and up to 91 cm (36 in.).
WARNINGS: Do not use the vehicle lap or lap/shoulder
belt when using the Universal Anchorage System (UAS).
Check UAS belt before each use. Use only if the belt can be
tightened properly and securely.
Store the tether hook when used rear facing.
Attach the tether hook to storage attach-
ment as shown and gently tighten to remove
slack.
Do not fasten both UAS connectors on the
same UAS anchor bar in the vehicle.
Fully recline the child restraint and rotate the child restraint
to the correct recline angle that matches the weight of your
child. Do not use any other recline positions rear facing. Do
not rotate the child restraint beyond the bottom or top level
lines.
Failure to follow these warnings can result in serious injury or
death.
Review your vehicle owner’s manual for UAS belt use.
continued on next page
2. Remove UAS from
Storage Location
1
2
3
3. Route UAS Connector
with Adjuster Closest to
It Through Rear-Facing
Belt Path
4. Reach Under Pad and
Pull Connector Across
to Opposite Side
Do not twist belt.
Belt MUST be in front of buckle
strap.
5. Finished UAS Routing
Replace pad over corners.
Adjuster MUST be on left side of
the child restraint as shown.
You
MUST use the 1st or 2nd buckle slot. Do not place belt
over child’s legs.
4358-6870 CAN Alpha Select ENG.indd C31-C324358-6870 CAN Alpha Select ENG.indd C31-C32 2/10/16 12:18 PM2/10/16 12:18 PM