3 4
Prepare Child Restraint to Fit Your Child How Does Your Child Fit?
1. Fully Loosen Harness
Strap
Push down on harness release
lever (under fl ap on front of seat
pad) while pulling out on harness
strap as shown.
3. Release Chest Clip
Press on chest clip release button
and pull apart.
Place harness strap out of the way.
2. Unbuckle Harness
Press in towards the top of the red
button.
Pull buckle tongues out.
4. Place Child in Child
Restraint to Determine
Proper Harness Fit
The child’s bottom and back should
be fl at against the child restraint.
See page 4 for fi t guidelines.
To make changes to the buckle, see pages 5-6.
To adjust the headrest/harness strap, see page 7.
Use the guidelines below to determine if the buckle and harness
strap are in the right place for your child.
REAR FACING
FORWARD FACING
Start in the 1st slot and adjust outward as your
child grows. Buckle should be used in the slot
closest to your child. The buckle should not be
underneath or behind your child. Any slot can be
used.
Always choose the shoulder harness slots that are
closest to your child’s shoulder height. Harness
strap MUST be at or slightly above shoulders.
If the upper shoulder harness slots are below the
child’s shoulders with the headrest in the highest
position and the child weighs at least 18 kg (40 lb) and is at least 4
years old, you must convert the child restraint to a booster seat.
Start in the 1st slot and adjust outward as your
child grows. Buckle should be used in the slot
closest to your child. The buckle should not be
underneath or behind your child. 1st or 2nd slot
MUST be used.
Always choose the shoulder harness slots that are
closest to your child’s shoulder height. Harness
strap MUST be at or slightly below shoulders. If
the lower shoulder harness slots for smaller infants
are above the child’s shoulders with the headrest in
the lowest position, do not use this child restraint.
4358-6870 CAN Alpha Select ENG.indd C3-C44358-6870 CAN Alpha Select ENG.indd C3-C4 2/10/16 12:18 PM2/10/16 12:18 PM