Insert the 50mm blade into the body. Wind the Adjustable Dial until the blade is retracted past #4.
Press the 50mm and 58mm blades at the same time, towards the centre of the body until a “click”
sound can be heard.
Adjust the Razor™ to the setting in the table below for your Sage® espresso machine. This is a
starting point for your dose height.
After tamping the coffee, insert the Razor™ into the filter basket until it rests on the rim of the basket.
The blade of the dosing tool should penetrate the surface of the tamped coffee.
If the blade does not penetrate the surface of the tamped coffee, your coffee is under dosed.
Increase the amount of dosed coffee by adjusting the GRIND TIME dial.
Rotate the Razor™ back and forth while holding the portafilter on an angle over the knock box to trim
off a little excess coffee.
Step 5:
Select Your Grind Size
For espresso, we recommend starting with grind size setting 15 and rotating the Hopper (to adjust the
Grind Size Collar) either coarser or finer.
To Next Page
Loading...
