6
0715
General
Test the Alarm Panel
Pressing and holding the Test button will make all light indicators and alarm buttons flash.
Pressing any other button while holding the Test button, will sound the buzzer enabling
verification of the buttons and the audible indicator.
Note that this only tests the Alarm Panel itself and does not involve the connected trans-
ceiver unit. For description of system test procedures, please refer to the User’s Manual of
each of the system.
Mute the alarm sound
If the buzzer is on, pressing the Mute button will mute the buzzer until reactivated by a new
event.
Adjust the light intensity
Pressing and holding the Dimmer button will increase or decrease the light intensity in the
display. To change between increasing and decreasing, release the button and press it
again. The light can be decreased to distinction, but it will always turn to full intensity if any
distress indicators turn on, or if the Test button is pressed.
40673
To Next Page
Loading...
Need help?
General