Saipa tiba - Page 140

140
Engine oil and lter
Changing engine oil and lter
The time intervals of the engine
oil and air lter change, should
be according to the scheduled
maintenance of the vehicle
explained in the current chapter.
1- Start the engine for several
minutes and then turn it off. Open
the engine oil ll cap.
2- By removing the oil ll cap and
opening the drain screw, drain
the oil into a suitable pot.
3- Open the oil lter using the
special tool.
4- Clean with a piece of clean
cloth the assembling location of
oil lter.
5- Soak the new O-ring in the
engine oil.
6- Tighten the drain screw after
completely draining the oil.
7- Install the oil lter using the
special tool.
8- Fill the new oil into the engine
until its level reaches at 'F'. Be
careful do not add oil more than
the specied limit.
9- Tighten the oil ll cap carefully.
10- Start the engine and check if
there is any oil leakage around
the O-ring of oil lter carefully.
11- Check the oil level and if it is
required, ll the oil until it reaches
at F level.
Caution
Both the engine and its oil are
hot, be cautious do not injure
yourself.
Note
Be careful the O-ring of old oil
lter to be removed. Otherwise
it may cause the oil leakage and
engine damage.
Oil Capacity
3.4 liters when replacing the oil
lter
3.1 liters without replacing the
lter
- Be careful about the oil to have
the proper specied quality.
Attention
- Although the oil lters may be
identical in appearance, their
internal design can be different.
These kinds of lters cannot be
used.
To protect engine from damage,
use only the specied lter (consult
an authorized SAIPA dealer).
- Follow the instruction. If you do
not install the oil lter properly, the
oil will leak and this will damage
the engine.
7