Saipa tiba - Brake System

145
Checking Brake uid level
Before adding uid, clean the
brake uid reservoir exterior to
protect it from contamination. If
you want to add brake uid into
its reservoir, ll it until its MAX
level due to its reduction during
vehicle driving. The gradual
reduction of brake uid level is
normal and it is not related to
the wearing out of the brake
linings.
Every time check the brake uid
level inside the reservoir. The
level must be between the MAX
and MIN marks.
If you have noticed that the level
is very low, consult an authorized
SAIPA dealer for inspection of
the brake system.
Only use the specied proper
type of brake uid and do not mix
it up with other type of uid (refer
to the section of recommended
brake uids in this chapter).
Attention
If the brake uid level goes
down constantly and you
need to add the brake uid
more frequently, consult an
authorized SAIPA dealer.
7
OWM126
Brake
Environment and vehicle
Brake uid is a synthesis com-
pound, which most part of it is the
enteric poly glycol compounds.
Therefore, never pour it on the
soil and through the water.