84
Wipers and washers
Windshield Wipers
To operate the wipers the wipers
on, turn the ignition switch to
the on position and pull down
the windshield lever as shown
in the gure at desired positions
explained below:
INI- In this position you can set
the length of delay between
wipers cycle by turning the delay
adjuster at the desired Position.
S: Slow speed, F: Fast speed
I-Low speed wipers Condition
II-High speed wipers Condition
OFF- In this position the wipers
are off.
Single Wiping Cycle
For a single wiping cycle, push
the windshield lever forward and
release it in OFF position
Attention
-To prevent the wipers and
windshield damage, do not
operate the wipers when the
glass surface is dry.
- To prevent damaging of
wiper blades, do not allow
them gasoline, Kerosene, and
other oil-based solvents to
touch them .
-To prevent damaging of the
wiper arms, do not move them
manually.
OWM089
OWM090
4
To Next Page
