Saipa tiba - Page 154

154
Tires and wheels
Tires and wheels
Attention:
- The warm tire ination pressure
is 4-6 Psi (28-41kpa) larger
than the cold one. Therefore,
do not use warm tire to adjust
its ination pressure, otherwise
after cooling the ination
pressure will be lower than the
specied limit.
- If the tire ination pressure
becomes lower than the
specied limit, the wear rate of
the tire and the fuel consumption
will increase and the control
of the vehicle will be difcult.
Also, low ination pressure tire
can explode and its sealing
with ring will not be enough.
If the tire ination pressure
becomes much lower than the
minimum specied value, it will
cause deformation of wheel or
separation of tire; therefore,
Warning
The tire ination pressure
more or less than the
recommended limit reduces
the tire life time and causes
bad handling of the vehicle
in driving. Also, it can cause
tire cut or blow up resulting in
loose of the vehicle control.
7
keep the tire ination pressure
in the specied limit. If the tire
ination pressure continuously
reduces, consult an authorized
SAIPA dealer or a puncture
shop.
- The tire ination pressure
more than the specied limit
causes knocking during driving,
difculty in vehicle control, wear
in the tire middle part, and more
likely of overturn.
Environment and vehicle
Tire
If only one of the vehicle tires has
pressure drop, say 6 psi (0.4 bar ap-
proximately), and the others have
standard pressure, the fuel consump-
tion increases to 3% and the life of
that tire would decreases.
You can reduce the fuel consumption
to 6% by regulating the tire pressure.