Power on
1. Slide the Charger/Camera switch on the side of the camera to Camera status.
2. Press the Power/Menu button once to turn on your camera. The LCD screen will light up and the
camera will sound a beep to confirm that the camera is on and ready for use.
Power off
1. Press and hold the Power/Menu button for about 2 seconds. The camera will sound continuous
beeps and then switch off.
Note: the camera will turn off automatically if unused for 60 seconds, in order to conserve energy. Simply
press the Power/Menu button to reactivate it.
Lithium Battery
Before using your camera for the first time, charge your camera’s battery. Once the battery is charged, move
the Camera/Charger selector to “Camera” mode. Do not move the selector back to “Charge” mode until you
have downloaded all your photos to your computer and are ready to recharge the camera. Switching to
Charge mode will erase all the photos on your camera.
To recharge your camera’s battery, connect the camera to your computer with the USB cable and move the
Camera/Charger selector to “Charge” mode. When the batteries are recharging, the icon will flash on the
LCD screen. Once the batteries are fully charged. The icon will disappear. The camera will function
normally while charging.
We recommend charging your camera’s battery every 7 days or when you have used up the full memory
capacity of the camera.
- -
12
To Next Page
Loading...
