SKI650 Series
- 6 -
Chapter 1 How It Works
The
SKI650
solar pumping system serves to provide water in remote applications
where electrical grid power is either unreliable or unavailable. The controller can
convert DC from the PV array to AC，and drive kinds of pumps. In sunny days, the
SKI650
solar pumping system can continuously pump water. The system without
batteries and other energy storage devices, it is recommended to take water
pumped to a reservoir for later use and water sources are those natural or special
such as river, lake, well or waterway, etc. A float switch can be installed in the
water tower to control the pump operation. And install a low-levelprobe in well to
detect the well water so that when the water shortage pump is stopped. Figure 1
shows a typical diagram of a
SKI650
solar pumping system. The major parts and
components in the system are listed after the diagram.
Figure 1
SKI650
solar pumping system
The
SKI650
solar pumping system is designed which consists of:
A. Solar Array
B. DC Breaker or Disconnect Switch
F. Water Tower
Float Switch
E. Well
Level Switch
D. Pump
A. PV Array
C.
SKI650
Solar Pump Inverter
B. DC Breaker
To Next Page
Loading...
