Sako V780 - Page 48

42
P9 Fault and Protection
Function
Code
Parameter
Name
Setting Range Default Property
P9-39
Bus voltage upon
1
st
fault
－ - ●
P9-40
Input terminal
status upon 1
st
fault
－ - ●
P9-41
Output terminal
status upon 1
st
fault
－ - ●
P9-42
AC drive status
upon 1
st
fault
－ - ●
P9-43
Power-on time
upon 1
st
fault
－ - ●
P9-44
Running time upon
1
st
fault
－ - ●
P9-47
Fault protection
action selection 1
Unit's digit (Motor overload, 11)
0: Coast to stop
1: Stop according to the stop
mode
2: Continue to run
Ten's digit (Power input phase
loss, 12)
Same as unit's digit
Hundred's digit (Power output
phase loss, 13)
Same as unit's digit
Thousand's digit (External
equipment fault, 15)
Same as unit's digit
Ten thousand's digit
(Communication fault, 16)
Same as unit's digit
00000 ☆
6.1 Brief introduction of function code