Sakura Tissue-Tek TEC 6 - Installation Method

22
Checking after Unpacking
Conrm that all of the accessories are present (refer to the table below) and
the instrument and accessories are free from damage.
If the instrument is damaged or any of the accessories are missing or
damaged, contact the Sakura instrument distributor or representative.
Name of part Quantity Remarks
Power cord 1 Housed in the instrument
Control cable 1
Operating Manual 1 Inside the box
2.1.4 Installation Method
If you have any questions on how to install the instrument, contact the Sakura
instrument distributor or representative.
Before moving the instrument, if it has been previously installed, conrm that
no molten parafn is left inside the Embedding Module or any parafn left in
the module is cool and solid.
Installing the Instrument
1. Select a work bench that has enough space to allow the Embedding
Module and Cryo Module to be placed on, and enough strength to
withstand the mass of the instrument containing parafn (approx. 55 kg).
The left, right and rear sides of the instrument can be in contact with
walls, etc. On top of the work bench, at least 80 cm of space is required
so that parafn can be added.
NOTE:
The instrument can be placed on a work bench with a depth of 60
cm or more.
2. Select on which side of the Embedding Console the Cryo Module is
クライオ・モジュール エンベディング・モジュール
約 91
cm
約 65
cm
Cryo Module Embedding Module
Approx. 91cm
Approx. 65 cm