What to do if Salicru UPS does not start?
If your Salicru UPS doesn't start, first ensure it's connected to a 220-240 V 50/60 Hz power socket. If connected, the ‘On-Off’ button might be preventing startup due to a safety feature. To resolve this, with the device on, press the button to switch it off. After 10 seconds, press the button again to switch it back on. If these steps don’t work, contact your distributor or seller.
What to do if Salicru UPS output sockets do not supply voltage?
If the Salicru UPS output sockets aren't supplying voltage, it could be due to a breaker tripped by an overload. An audible alarm (a long beep) will sound if an overload is detected. To fix this, switch off the UPS, disconnect the load exceeding the rated power of the output sockets with backup, wait 10 seconds, and check that the fuse or circuit breaker of the line supplying the UPS is correct or set to ‘On’. Then, restart the UPS by pressing button 5. Alternatively, the battery may be discharged; connect the UPS to a power socket for at least 4 hours, preferably without any load connected.
Why is Salicru UPS backup time not as expected?
If the Salicru UPS backup time is not as expected, the battery may not be fully charged. Connect the UPS to a power socket and allow it to charge for at least 8 hours. If the issue persists, the battery might be slightly damaged, so contact your distributor or seller.
How to fix inactive Power Master on Salicru UPS?
If Power Master is inactive on your Salicru UPS, ensure the serial port/USB cable is correctly connected between the UPS and your computer, using the cable supplied with the unit. If the cable is connected, and the issue persists, it may be that SPS.HOME does not provide battery power. Switch on your PC and UPS, wait 10 seconds, and then restart SPS.HOME. This should resolve the fault.
Thanks for purchasing the product and advice to read the manual carefully before use.
Explains the purpose of the manual and how to interpret its contents.
Company policy on Quality and Environmental Management Systems.
Product conformance to EN ISO 9001 and relevant EEC directives.
Guidelines for recycling the device and its packaging at end of life.
Illustrates the equipment's external parts and indicators.
Details the system's design, operating principle, and key features.
Critical warnings and precautions for safe installation and operation.
Procedure for visually checking the equipment for transport damage.
Guidelines for selecting a suitable and safe installation location.
Instructions for charging the UPS battery before initial use.
Steps to connect a computer to the UPS for backup power.
How to connect peripherals to surge-protected outlets.
Connecting phone lines for protection against transient voltages.
Connecting the UPS to a computer via USB for monitoring.
Instructions for powering the UPS on and off.
Enables starting the UPS without mains power when the battery is charged.
Provides steps to resolve common UPS operational issues.
Detailed procedure for replacing the UPS internal battery.
Information regarding warranty terms, coverage, and limitations.
Lists national and international service points for technical support.
Detailed technical data and specifications for SPS.HOME models.
General| Outlets | IEC C13 |
|---|---|
| Number of Outlets | 4 |
| Surge Protection | Yes |
| Data Line Protection | No |
| Topology | Line Interactive |
| Output Frequency | 50/60 Hz |
| Recharge Time | 6 hours |
To Next Page