Sam4s ER-180T Series - Self Test

3. Installation and Operation
3-14 SAM4S ER-180T SERIES
3-2 Operation
3-2-5 Self Test
3-2-5-(a) Test Printer
1. Turn the Mode switch to Service Mode position.
2. Press ‘1’, ‘0’ and ‘SUB TOTAL’ key on key board.
3. Then the printer prints the test pattern.
4. After printing, The drawer is opened. Then the printer test is finished.
3-2-5-(b) Test Display
1. Turn the Mode switch to Service Mode position.
2. Press ‘1’, ‘1’ and ‘SUB TOTAL’ key on key board.
3. Check the Display.
3-2-5-(c) Test Key Board
1. Turn the Mode switch to Service Mode position.
2. Press Press ‘1’, ‘2’ and ‘SUB TOTAL’ key on key board.
3. Press each key on the keyboard one key at the time.
As you press each key. The Display shows the key’s location code.
3-2-5-(d) Test Mode Switch
1. Turn the Mode switch to Service Mode position.
2. Press Press ‘1’, ‘3’ and ‘SUB TOTAL’ key on key board.
3. Turn the Mode key and check the display.