Sam4s NR-510B - Check

136 • Program Mode Programming SAM4S NR-500 Series Manual
CHECK #
CHECK # Key Program Notes
Option Entry Description
DESC Alpha
numeric
24 character
You can program a unique descriptor. The default
descriptor is CHKTRACK.
KEY DISABLE Y or N
Select Y to disable this function.
COMPULSORY
FOR ALL SALES
Y or N
Select Y you must begin a new, or recall an existing
tracking number before registering items.
OPENING
CLERK HAS
EXCLUSIVE
ACCESS
Y or N
If Y, the clerk that begins a tracking number is the only
clerk who can recall a check. If N, any clerk can recall
any check.
PRINT ON
RECEIPT
Y or N
If N, the check track number and balance will not print on
the receipt.
PRINT ON
REMOTE
Y or N
If N, the check track number and balance will not print on
the remote.
ALLOW ONLY
ONE CHK PER
TABLE
Y or N
If Y, you can begin only one check with the same table #.
CHECK #
ASSIGNED BY
REGISTER
Y or N
If Y, press the CHECK. # key to automatically assign
the next sequential check. Check numbers will begin with
#1 and continue until the open check report is reset, at
which point the check number will be reset and start from
#1 again.
DRIVE THRU
FEATURE
ENABLED
Y or N If you wish to implement a drive thru recall key, this
setting changes the function of the PBAL key to that of a
recall key. Press the PBAL key directly to automatically
recall the open check with the lowest tracking number
LENGTH OF
CHECK (0-9)
Y or N Set the length of check in number of digits. For example,
if 4, then checks must be used in the range from 1000, to
9999. This setting applies to only check numbers input
by the operator, not to check numbers assigned by the
register.
SCAN CHECK # Y or N
Choose Y to allow the check number to be inputted by a
scanner (must be nine digits or less).