SPS-300 SmartECR Supplement v1.11 SPS-300 Series Program Information • 19
System Option Definitions
SmartECR related system option definitions.
EFT DRAFT IS Y or N Set to Y: mBox for a normal draft with SmartECR.
N: FINE DINING is not used with SmartECR.
MSR CONNECTED 0, 1 or 2 Set to 0: reserv. Setting to 1 or 2 is not supported.
PIN PAD TYPE Y or N Always choose Y: D UKPT (only type supported.)
PIN PAD (0-4) 0 - 4 Set to 0 when using SmartECR.
NO SIGN IF
TRANSACTION TTL
LESS THAN 0.00
00.00 Leave at 00.00, is not used with SmartECR
Reserved 0 Leave at 0.
TRANS PLUs TO MPP Y or N Always N, not used with SmartECR.
INPUT CVD ? Y or N Select Y if you want to require input of the CVD
(Card Verification Data) security code.
INPUT AVS ? Y or N Select Y if you want to require input of the AVS
(Address Verification Service) security code.
DEBIT CASH BACK Y or N Select Y to allow cash back on Debit Card
transactions.
GIFT CARD CASH OUT Y or N Select Y to allow Cash Out on transaction tendered
with a Gift Card.
EFT SUPPORT NEW
EMV PROTOCOL
Y or N Select Y when integrated payment equipment is
setup to accept EMV (chip cards).
To Next Page
Loading...
