18 • SPS-300 Series Program Information SPS-300 SmartECR Supplement v1.11
System Option Programming
Pages 21-23 of the system options differ from the standard SPS-300 Series application. Read each option
carefully to determine if you wish to make any changes.
Programming a System Option:
1. At the PGM control lock position menu, press 3 for SYSTEM OPTION Programming. The
SYSTEM OPTION P1 screen displays:
2. Use the PAGE UP and/or PAGE DOWN keys to view the appropriate option page.
3. Press ENTER (cash key) to advance to the desired option.
4. Make selection changes; press ENTER after making a change. If you don’t press enter, the
change will not be saved.
SYSTEM OPTION P21
EFT DRAFT IS Y
Y:mBOX N:FINE DINING
MSR CONNECTED 0
0:reserv 1:reserv 2:REGISTER
PIN PAD TYPE Y
Y:DUKPT N:ROTAT
PIN PAD (0-4) 0
SYTEM OPTION P22
NO SIGN IF TRANSACTION 0.00
TTL LES THAN
Reserved 0
MGR REQUIRED TO OPEN CHECKS N
ALLOW Z CLERK TIME REPORT
IF EMPLOYEES ARE CLOCKED IN N
SYTEM OPTION P23
TRANS PLUs TO MPP N
INPUT CVD ? N
INPUT AVS ? Y
DEBIT CASH BACK Y
GIFT CARD CASH OUT N
CANDIAN ROUNDING ON CASH Y
EFT SUPPORT NEW PROTOCOL Y
To Next Page
Loading...
