Sam4s SPS-345 - Page 40

40 • Integrated Payment Operations SPS-300 SmartECR Supplement v1.11
4. Enter a command from the table below and press the CASH key, or
Enter 999 and press the CASH key to print the MPP command list, or
If you are selecting Reports (703) or Diagnostics (713) enter the code representing the specific
report or function you wish to perform.
5. Press CLEAR to exit this screen and return to the Reset Report Menu.
MPP FUNCTION
COMMAND : 700-709,713,777
< COMMAND + ‘CASH’ >
EXIT : ‘CLEAR’
HELP : 999 + ‘CASH’
0
Sterling MPP Command List
Function Procedure
TIP Command Z-Mode: Enter 700, press CASH
Batch Close with Debit
(closes batch and/or initiates
polling)
Z-Mode: Enter 702, press CASH
Reports: Z-Mode: Enter 703, press CASH
Enter “0” then press CASH = Summary Report
Enter “1” then press CASH = Detail Report
Enter “2” then press CASH = Clerk/Cashier Report
Enter “3” then press CASH = Unadjusted TIP Report
Reset Modem Z-Mode: Enter 704, press CASH
Reset PIN Pad Z-Mode: Enter 705, press CASH
Voice Auth Z-Mode: Enter 706, press CASH
Credit Card Status Check Z-Mode: Enter 707, press CASH
Prepaid Card Balance Z-Mode: Enter 708, press CASH
Request UID Z-Mode: Enter 709, press CASH
Diagnostics: Z-Mode: Enter 713, press CASH
Enter “0” then press CASH – Menu
Enter “1” then press CASH – Connectivity Test
Enter “2” then press CASH – UID Information
Input Serial Number Z-Mode: Enter 777, press CASH
Enter “ECR Serial Number” then press CASH