Why does my Samlexpower VR175 Inverter low battery alarm sound?
If your Samlexpower Inverter's low battery alarm is sounding, it's likely due to low battery voltage. Try recharging or replacing the battery to resolve this issue.
What to do if Samlexpower VR175 has no AC output (latch up) with both Red and Green LEDs lit?
If your Samlexpower Inverter is not providing AC output and both the red and green LEDs are lit, it indicates that the earth fault protection has been activated due to excessive current leakage from the load. To fix this, unplug the faulted load.
Why won’t my motorized power tool start with my Samlexpower Inverter?
If your Samlexpower Inverter's motorized power tool won’t start, the appliance is likely drawing excessive wattage and is not compatible with the inverter. In this case, the suggested solution is that if the appliance does not start, then the appliance is drawing excessive wattage and will not work with the inverter.
How to troubleshoot no AC output on Samlexpower VR175 with red LED lit and green LED off?
If your Samlexpower Inverter has no AC output, the red LED is lit, and the green LED is not lit, it could be due to a DC input below 10 volts or the inverter overheating. Recharge or replace the battery if the DC input is too low. If it's overheating, remove or reduce the load and wait for the inverter to cool down.
What to do if Samlexpower Inverter has non-continuous AC output with Red LED flashing?
If your Samlexpower Inverter is producing non-continuous AC output with the red LED flashing on and off while the green LED is lit, it means the inverter's output power is being limited by an overload or short circuit protection. Reduce the load or remove the short circuit to resolve this.
How to fix TV/radio interference with Samlexpower VR175 Inverter?
If you are experiencing TV/radio interference such as snow in the picture or a buzz in the speaker when using your Samlexpower Inverter, it could be due to the appliance being too close to the inverter. Try keeping the inverter and antenna distant from each other, using a shielded antenna cable, and connecting the antenna with an amplifier.
What causes an abnormal low battery alarm sound on a Samlexpower VR175 Inverter?
If the low battery alarm on your Samlexpower Inverter sounds abnormal, it might be due to a bad connection or wiring. Ensure you tighten all DC connections to resolve this issue.
Why does my motorized power tool run at the wrong speed on my Samlexpower Inverter?
If your motorized power tool does not operate at the correct speed when using a Samlexpower Inverter, it may be due to a purely inductive load. To resolve this, make the load not purely inductive by operating an incandescent lamp at the same time as the motor.
Output Specifications| output connection | One Universal AC Receptacle |
|---|---|
| output voltage | Approx 230 volt AC RMS 50 Hz |
| output waveform | Modified Sine Wave (filtered) |
| max efficiency | Approximately 90% |
Input Specifications| input voltage range | 10.5 to 15.5 volt DC |
|---|---|
| low voltage alarm | 10.6 volt DC |
| low voltage shutdown | 10.0 volt DC |
| no load input current (switch on) | 0.4 amps |
To Next Page
