Sammy Atomiswave - Introduction; Product Specifications

Introduction
Thank you very much for purchasing the ATOMISWAVE system board.
This book is an instruction manual for the system board.
Written for the owner, manager and administrator of the product, it covers instructions on how to
use
the product safely,
including
administration, maintenance
and inspections.
Have only those persons who have read through this manual carefully administer,
maintain
and inspect the product. Keep the manual in a safe place so you can refer back to it during its
routine
administration
as
needed.
Information
in the manual is subject
to change
without
notice
for product
improvement
purposes.
Read Before Using the Product
Read through these instructions thoroughly before using the product to ensure that you fully
understand them so you can use the product safely.
eThis system board is a JAMIMA-compliant (56-pin edge terminal) product.
@ Specifications
Physical Dimensions 271 mm (H) x 229.4 m (D) x 63.8 mm (H)
If you lose this manual, notice inaccuracies in it or have comments or suggestions, please
contact
the following:
(Sammy Corporation
=
2-23-2, HIGASHI-IKEBUKURO, TOSHIMA-KU, TOKYO, 170-8436 JAPAN
PHONE: +81-3-5950-3805, FAX: +81-3-5950-3761
Sammy
USA Corporation
901 CAMBRIDGE DRIVE, ELK GROVE VILLAGE, IL 60007-2434,
U.S.A.
PHONE:
(847)
364-9787 FAX: (847) 364-9831
Sammy Europe
Limited
FIRST FLOOR, HEALTHAID HOUSE, MARLBOROUGH HILL,
HARROW,
MIDDLESEX
HA1 1UD, U.K.
PHONE: +44-20-8427-8427 FAX: +44-20-8861-1209
S
The addresses and phone numbers described above
are
as
of December 2002.