Samoa Larius 2 Transfer - H SETTING-UP; INSTALLATION; CONNECTION TO THE REED AIR; SUCTION AND DELIVERY HOSES CONNECTION

H
I
Check all the connection fittings of the
components (pump. flexble hose, etc.) before
using the equipment.
Avoid pump iding because it could damage the
pneumatic system and the membranes.
SETTING-UP
INSTALLATION
• 
holes.
NEVER INSTALL 
CONNECTION TO THE REED AIR
• For pump feed use a hose with a internal diameter no lower
than 6 mm.
SUCTION AND DELIVERY HOSES CONNECTION
• 

• 
WASHING OF THE BRAND NEW EQUIPMENT
• The LARIUS 2 pump has been tested at our plant with light

        
diluent.
• 


WORKING
• 
• 


• 


The high speed of travel of the product in the hose
can create static electricity through discharges
and sparks. It is suggested to earth the equipment.
The pump is earthed through the earth cable of
the supply.
The gun is earthed through the high pressure
flexible hose.
All the conductors near the work area must be
earthed.
Avoid approaching too much to the pump piston
rod when the pump is working or under pressure.
A sudden movement of the piston rod can cause
wounds or finger squashing.
Never spray over flammable products or solvents
in closed places.
Never use the tooling in presence of potentially
explosive gas.
Always check that the product is compatible with
the materials composing the equipment (pump,
spray gun, flexible hose and accessories) with
which it can come into contact. Never use paints
or solvents containing Halogen Hydrocarbons
(as the Methylene Chloride). If these products
come into contact with aluminium parts can
provoke dangerous chemical reactions with risk
of corrosion and explosion.
If the product to be used is toxic, avoid inhalation
and contact by using protection gloves, goggles
and proper face shields.
Take proper safety measures for the protection
of hearing in case of work near the plant.
   TIGHTEN AND CHECK ALL THE FITTINGS
FOR CONNECTION BETWEEN PUMP, FLEXIBLE HOSE AND
SPRAY GUN BEFORE USING THE EQUIPMENT.
 -
DARD KIT.
 
THOSE RECOMMENDED IN THIS MANUAL, MAY CAUSE
DAMAGE OR INJURE THE OPERATOR.
 
DANGEROUS. HANDLE THE FLEXIBLE HOSE CAREFULLY. DO
NOT PULL THE FLEXIBLE HOSE TO MOVE THE EQUIPMENT.
NEVER USE A DAMAGED OR A REPAIRED FLEXIBLE HOSE.
www.larius.com
6
LARIUS 2 - TRAnSfeR
ED. 07 - 09/2020 - Cod. 150146