Samoa Larius 2 Transfer - J PROBLEMS AND SOLUTIONS; Pump Does Not Start; Accelerated Working and Non-Suction; Pump Stalls Continually

J1
J1
J2
J4
J3
J3
J4
J1
J1
J1
J1
J2
J4
J3
J3
J4
J1
J1
Always close the air compressed supply and
unload the plant pressure before performing any
check or replacement of pump parts.
J
 

pump
  (J2) (J4)
(J1) 
the hole (J3) of the pump body (see picture below).
Problem Possible cause
Solution
The pump does not start        
diameter of the feed hose.
     
hose, feed the pump at minimum

wihout the outlet hose.
 
filer. Clean.
 
 
the sider of the valve.
Accelerated working and non-
suction of the pump
 
 
 
th balls and their seats.
The pump stalls continally        
diameter of the feed hose.Verify if the
  


 
Fig. 1J Fig. 2J
PROBLEMS AND SOLUTIONS
www.larius.com
7
LARIUS 2 - TRAnSfeR
ED. 07 - 09/2020 - Cod. 150146