Samson 2412 Series - Default Chapter; Table of Contents

Contents
EB 2512 EN 3
1 Safety instructions and safety measures .........................................................5
1.1 Notes on possible severe personal injury .........................................................8
1.2 Notes on possible personal injury ...................................................................8
1.4 Warning markings on the regulator ............................................................... 11
2 Markings on the device ...............................................................................12
2.1 Nameplates ................................................................................................. 12
2.2 Locations of the nameplate ...........................................................................13
2.3 Warnings ....................................................................................................13
2.4 Material number ..........................................................................................13
2.4.1 Type 2412 Valve .......................................................................................... 13
2.4.2 Type2413Actuator .....................................................................................13
3 Design and principle of operation ................................................................14
3.1 Technical data .............................................................................................16
4 Measures for preparation before installation ................................................23
4.1 Unpacking ..................................................................................................23
4.2 Transport, lifting and storage ........................................................................23
4.2.1 Transport ..................................................................................................... 24
4.2.2 Lifting ..........................................................................................................24
4.2.3 Storage .......................................................................................................25
5 Assembly ....................................................................................................26
5.1 Preparation for installation ............................................................................ 26
5.2 Checking the installation conditions ...............................................................27
5.2.1 Mounting position ........................................................................................27
5.2.2 Pipeline routing ............................................................................................ 28
5.3 Control line, compensation chamber and needle valve ....................................28
5.3.1 Control line .................................................................................................28
5.3.2 Control line kit .............................................................................................28
5.3.3 Compensation chamber ................................................................................ 28
5.3.4 Needle valve ...............................................................................................29
5.4 Additionalttings .........................................................................................31
5.4.1 Strainer .......................................................................................................31
5.4.2 Bypass and shut-off valves ............................................................................31
5.4.3 Insulation ....................................................................................................31
5.4.4 Pressure gauges ...........................................................................................32