Need help?Do you have a question about the Samson MD2 PRO and is the answer not in the manual?
General| Type | Passive Direct Box |
|---|---|
| Frequency Response | 18Hz - 40kHz |
| Channels | 1 |
| Output Impedance | 600 Ohms |
| Ground Lift | Yes |
| Output Connectors | XLR |
| Attenuation | -15dB |
| THD | 0.01% @ 1kHz |
| Connector | XLR |
| Impedance | 600 ohms |
| Sensitivity | -54dB (1.6mV) re 1V at 1 Pa |
| CMRR | >100dB @ 1kHz |
| Shielding | Mu-metal shielded transformer |
| Weight | 1.27 lbs (0.58 kg) |
1/4-inch hi-Z input jacks for connecting instruments and line-level signals.
1/4-inch outputs pass input signal to amplifiers or monitor systems.
Attenuates input signal by -10dB or -20dB to prevent distortion.
Sums stereo inputs to both outputs or routes them separately.
Disconnects the input ground (shield) to eliminate hum.
Male XLR low-impedance connectors for balanced audio output.
To Next Page
