Need help?Do you have a question about the Samson MDA1 and is the answer not in the manual?
General| Frequency Response | 20 Hz - 20 kHz |
|---|---|
| Input Impedance | 1 MΩ |
| Power | Passive |
| Ground Lift | Yes |
| Type | Direct Box |
| Inputs | 1 x XLR |
| Outputs | 1 x XLR (balanced) |
| Output Impedance | 600Ω |
| Attenuation | -20 dB, -40 dB |
LED status indicator for device power, which can be from battery or phantom power.
1/4" hi-Z input for instruments, line, or speaker level audio; powers off unit when disconnected.
1/4" output for passing the input signal to a stage amplifier or monitor system.
Switch to activate the internal 9 Volt battery when the INPUT jack is connected.
Male XLR low-Z connector for balanced audio output.
Attenuates input level by -15dB to prevent distortion with high-level signals.
Disengages the input ground (shield) when activated to reduce hum.
Compartment for installing a standard 9 Volt battery.
To Next Page
