Owner’s Manual
9
PXD1 Beltpack Transmitter Callouts
1. Input Connector - Connect
the input device via this
mini-XLR input jack.
The PXD1 is supplied
with either a lavalier or
headset microphone that is
wired to a P3 connector.
2. Status Indicator - This LED
displays the operation mode.
Amber: Normal Operation
Flashing Amber: Pairing / Low
Battery
3. Power/Pair Switch - Press <5
seconds to turn the unit on or
off. Press >5 seconds to enter
pairing mode.
4. Input GAIN Control - This
control adjusts the transmitter
input sensitivity.
5. Battery Holder - Open the battery holder by pressing the tab and lifting the cover.
Insert two standard AA (LR6) batteries here, being sure to observe the plus and
minus polarity markings shown.
WARNING: Do not insert the batteries backwards; doing so can cause severe
damage to the transmitter and will void your warranty.
6. Screwdriver - Used to adjust the input GAIN control.
To Next Page
Loading...
Need help?
General
