10
Use the included ¼” to ¼” cable to connect
the SR266 receiver to a karaoke machine.
3. While holding the upper section
of the HT6 transmitter, rotate the
bottom section and slide down to
expose the battery compartment.
Insert a standard 9-volt alkaline
battery, being sure to follow the plus
and minus polarity markings.
4. Turn on the HT6 transmitter by sliding the POWER
switch to the right, and replace the bottom section.
Quick Start Guide
5. Installing a 9-volt battery into the receiver.
3. Plugging the receiver into a stereo using the 1/4" - RCA cable.
4. Plugging the receiver into a Karaoke machine using 1/4" - 1/4" cable.
1. Plugging the receiver into the wall.
2. Plugging the receiver into a mixer using 1/4" - 1/4" cable.
4. Plugging the receiver into a Karaoke machine using 1/4" - 1/4" cable.
To Next Page
Loading...
