Need help?Do you have a question about the Samson Txm16 and is the answer not in the manual?
General| Channels | 16 |
|---|---|
| Microphone Preamps | 8 |
| Aux Sends | 2 |
| Microphone Inputs | 8 |
| Phantom Power | Yes |
| EQ Bands | 3-band |
Details controls for mono input channels, including EQ, sends, PAN, GAIN, VOLUME.
Explains controls for stereo input channels, covering EQ, AUX/EFX sends, and levels.
Describes the built-in 24-bit multi-effects processor, program selection, and controls.
Details the controls for stereo line inputs, including level, PFL, and AFL settings.
Explains master send controls for auxiliary buses, used for monitor mixes or effects.
Covers headphone output level and CD/TAPE input controls.
Details the mono output, its use for zones or subwoofers with a low-pass filter.
Describes controls for the main stereo mix output, including peak LEDs and level fader.
Explains the power amplifier section, including mode switch, peak limiter, and phantom power.
Details the 9-band graphic equalizer for the monitor (Aux 1) mix bus.
Describes the 9-band graphic equalizer for the main stereo mix bus.
Covers mono mic/line inputs, including XLR, LINE, and Insert connectors.
Details stereo inputs via RCA and 1/4-inch jacks for various line-level sources.
Explains connectivity for cassette recorders or computers for input and output.
Covers master connectors like PHONES, FOOTSWITCH, MAIN OUT, and INSERT points.
Details the rear panel connections, including speaker outputs and amplifier modes.
Provides guidance on connecting speakers to the amplifier outputs, including impedance considerations.
Outlines the fundamental steps for operating the mixer.
Guides on properly connecting microphones and instruments to the mixer inputs.
Explains how to select and use the built-in digital effects processor.
Details how to create a separate monitor mix using auxiliary outputs and external amps.
Describes how to connect and use external effects processors via the EFX bus.
Explains using insert points for external processors on the main stereo mix.
Guides on recording the mixer's audio output to external devices.
Details connecting the mono output to a subwoofer system using the low-pass filter.
To Next Page
