Need help?Do you have a question about the Samson TXM20 and is the answer not in the manual?
General| Type | Analog |
|---|---|
| Channels | 20 |
| EQ Bands | 3-band |
| EQ | Yes |
| Aux Sends | 4 |
| Phantom Power | Yes |
| Outputs - Main | 2 x XLR, 2 x 1/4" |
| Line Inputs | 20 |
| Outputs - Aux | 4 x 1/4" TRS |
| Faders | 60mm Faders |
| Power Supply | Internal |
Details controls for mono input channels including gain, EQ, and volume.
Details controls for stereo input channels, including gain, EQ, and level.
Explains the operation and controls of the built-in digital effects processor.
Describes the controls for stereo line input channels, including AUX sends.
Details the master faders for auxiliary send outputs.
Explains controls for headphone output and CD/TAPE inputs.
Details controls for the mono output, including subwoofer functionality.
Describes controls for the main stereo mix output, including faders and meters.
Engages dynamic processing to prevent amplifier clipping and distortion.
Provides 48V power for condenser microphones.
Selects amplifier operating modes: stereo, mono, or bridged.
Indicates activation of the amplifier protection circuit.
Nine-band graphic EQ for contouring the monitor mix bus signal.
Nine-band graphic EQ for contouring the main stereo mix bus signal.
Details mono mic/line input connectors and their functions.
Describes stereo input connectors using both 1/4-inch and RCA types.
Details master connectors for interfacing external gear and outputs.
Explains the rear panel speaker output connectors and wiring.
Provides guidance on connecting speakers to the amplifier section.
Explains the fundamental steps for operating the mixer.
Step-by-step guide for connecting audio sources to the mixer.
Details how to use the built-in 24-bit digital effects processor.
Guides on creating separate monitor mixes using auxiliary buses.
Instructions for connecting and using external effects processors.
Describes using main insert points for external processor effects.
Explains how to connect the mixer to a recorder for audio capture.
Details how to configure the MONO output for subwoofer use.
Explains how to interface the mixer using various connectors.
Details wiring for unbalanced 1/4" connectors.
Details wiring for balanced TRS 1/4" connectors.
Explains XLR balanced wiring for microphones.
To Next Page
