10
English
Installation Procedure
Installation Procedure
Moving the outdoor unit with wire rope
1 Before carrying the outdoor unit, fasten two wire ropes of
8 m or longer, as shown in the figure.
2 To prevent damages or scratches effectively, insert a piece
of cloth between the outdoor unit and the ropes.
3 Move the outdoor unit.
Wire rope
Plate protection
cloth
Step 2 Checking and preparing
accessories and tools
Energy Label Rubber Leg
ENERGY ENERG
=-.%
-%-)
Installation Manual
NOTE
• Wire assembly cables are optional. If they are not
supplied, use standard cables.
• The rubber legs are included only when the air conditioner
is supplied without assembly pipes.
• If these accessories are supplied, they are in the
accessory package or outdoor unit package.
Step 3 Fixing the outdoor unit in place
Install the outdoor unit on a rigid and stable base to prevent
disturbance from any noise caused by vibration. When
installing the unit at a height or in a location exposed to
strong winds, fix the unit securely to a support (i.e., a wall or
a ground).
Fix the outdoor unit with anchor bolts. Make sure that the
anchor bolts are 20 mm or higher from the base surface.
(Unit : mm)
Anchor bolt hole
328~360
CAUTION
• When installing the outdoor unit on the roof,
waterproof the unit and check the ceiling strength.
• Make sure that the wall can support the weights of the
rack and the outdoor unit.
• Install the rack close to the column as much as
possible.
• Make sure that the rack is not placed under the drain
hole.
ki]_TXX]]ZhTWXptjhjGyZYGwytGv|{kvvyl|luUGGGXW YWYYTW\TY^GGG㝘㤸GXXa\Za[Y
To Next Page
Loading...
