Samsung AC***KNZDCH/AA - Checking and Inputting Options

35
ENGLISH
Option setting Status
13. Setting SEG16, SEG17 option
Press Low Fan button(
) to enter SEG16 value.
Press High Fan button(
) to enter SEG17 value.
Each time you press the button,
p p … p will be selected in rotation.
SEG16 SEG17
14. Setting Dry mode
Press Mode button to be change to Dry mode in the OFF status.
15. Setting SEG18, SEG20 option
Press Low Fan button(
) to enter SEG18 value.
Press High Fan button(
) to enter SEG20 value.
Each time you press the button,
p p … p will be selected in rotation.
SEG18 SEG20
16. Setting Fan mode
Press Mode button to be change to Fan mode in the OFF status.
17. Setting SEG21, SEG22 option
Press Low Fan button(
) to enter SEG21 value.
Press High Fan button(
) to enter SEG22 value.
Each time you press the button,
p p … p will be selected in rotation.
SEG21 SEG22
18. Setting Heat mode
Press Mode button to be change to HEAT mode in the OFF status.
19. Setting SEG23, SEG24 mode
Press Low Fan button(
) to enter SEG23 value.
Press High Fan button(
) to enter SEG24 value.
Each time you press the button,
p p … p will be selected in rotation.
SEG23 SEG24
Step 3. Check the option you have set
After setting option, press
button to check whether the option code you input is correct or not.
→
→
→
→
→
→
→
→
→
Step 4. Input option
Press operation button
pointing towards receiver kit to enter new option code.
For the correct option setting, you must press operation button twice.
Step 5. Check operation
1. Reset indoor unit after option code programming by cycling power at the outdoor unit. Leave power of for 5mins before
cycling power back on.
2. Take the batteries out of the wireless remote controller and re-insert them to exit out of option code programming mode.
Press operation button to turn unit back on.
Ź Set the indoor unit address and installation option with remote controller option. Set the each option separately since you
cannot set the ADDRESS setting and indoor unit installation setting option at the same time. You need to set twice when setting
indoor unit address and installation option.
jhjGvktG}Tho|ptuv{jvkllunUGGGZ\ YWX]TXWTX_GGG㝘㤸GXXaYXaY[