EasyManua.ls Logo

Samsung AC***KNZDCH/AA - Setting Installation Options

Samsung AC***KNZDCH/AA
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
38
Setting an indoor unit address and installation option
Set the indoor unit address and installation option with remote controller option. Set the each option separately since you cannot
set the ADDRESS setting and indoor unit installation setting option at the same time. You need to set twice when setting indoor unit
address and installation option.
Setting an indoor unit address
1. Press the and buttons at the same time for more than 3 seconds and then a Main menu will be displayed.
2. Press the
/ button to select and then press button to enter a Sub-menu setting screen.
3. Press the
/ button to select and then press button to enter a Indoor unit option code setting screen.
NOTE
t The Main/RMC Address which is currently setting will icker.
t Data bit 1 and 2 present Indoor unit main address checking.
t Data bit 3 and 4 present Indoor unit main address setting(outdoor unit reset is needed to set).
5. Press the
/
button to set the Indoor unit Main/RMC Address.
6. Press the
button to save and complete the option setting.
7. Press the
button to exit to normal mode.
NOTE
t Press the button to save and complete the option setting.
t Address will not be applied if you don't press
button.
t Setting Main/RMC Address of an Indoor unit is available only with a master wired remote controller.
Setting an indoor unit installation option
In order to check and set the indoor unit installation option code use the wired remote controller and follow the directions below.
1. Press the
and buttons at the same time for more than 3 seconds and then a Main menu will be displayed.
2. Press the
/ button to select and then press button to enter a Sub-menu setting screen.
3. Press the
/ button to select and then press button to enter a Indoor unit installation option code setting screen.
NOTE
t The rst digit represents the page number and the remaining ve digits are installation option.
t The total option codes are 24 digits. You can set six digits at a time and it is distinguished by page number (0, 1, 2,
3).
12 34 56
Data bit
jhjGvktG}Tho|ptuv{jvkllunUGGGZ_ YWX]TXWTX_GGG㝘㤸GXXaYXaY_

Related product manuals