Samsung AC024MNADCH/AA - Connecting the Cable

13. Installation
40
13-2. Outdoor unit
Outdoor Unit Support
Anchor bolt
0.79 inch
Outdoor
Unit
Base
Surface
Outdoor
Unit
Support
Designed
to cut off
residual
vibration from
outdoor unit
to rack.
ĮƸƟUĮĮŵƸĘÃƟÃĘƊƟøøkUĮĘŵÃƊkŵƊࢥƊƟĘUĮŵǮøøÃĘƊƟøøƟÃĮĘ
• Ensure the wall will be able to support the weight of rack and outdoor unit.
• Install the rack close to the column as much as possible.
• Install proper grommet in order to reduce noise and residual vibration transferred by outdoor unit towards
wall.

CAUTION
Ǯ˵ʪϑϩɇ˝ɇθ˝ЇʒʪʒЇʀϩ
• Check and make sure that screws do not damage the copper pipe.
• Secure air guide duct on guard fan.
Soft rubber designed to cut off
vibration from rack to wall.
(not supplied with product)
Connecting the cable
ƟиͱʪʪʀϩθͱʀʀɇɵʪϑЇϑϩɵʪʀͱʪʀϩʪʒϩͱϩ˵ʪͱЇϩʒͱͱθЇϩࢋ
• The connection cord between indoor unit and outdoor unit.
• The power cable between outdoor unit and auxiliary circuit breaker.
• Be sure to run the power supply cable and the communication cable through electrical conduit as seen in the
picture.
• Protect the power and communication cable using the protection tube individually.
• Make a knockout hole.
• After making a knockout hole, apply rust resisting paint around the hole.
• Secure the cable tube to the outdoor knockout using the CD connector and bushing.

CAUTION
• During the unit installation make first refrigerant connections and then electrical connections. If unit is
uninstalled first disconnect electrical cables, then refrigerant connections.
• Connect the air conditioner to grounding system before performing the electrical connection.
• When installing the unit, you shouldn't use inter connection wire.
Conduit