Samsung AC030JN4DCH - 4-3-13 Error of Compressor Startup and Rotation

Troubleshooting
Samsung Electronics 4-31
&SSPSPG$PNQSFTTPS4UBSUVQBOE3PUBUJPO
&SSPS$PEF&&
1. Test Item
1) Check the power supply / Check the restart-up after power is reset.
2) Check the compressor and the state of the compressor wire assembling.
3) Check the fault of the
single compressor wire.
2. Check procedure
Yes
30 seconds after power off, power on.
End the service.
No
Check power. /
Check the restart-up after power is reset.
1. Is there any problem in input power?
(Single-phase: 220Vac, 3-phase: 380Vac)
2. Does the error occur aga
in after power rest?
Yes
1. Compressor replacement: If the inter-phase
resistance values of the compressor are
different. ױ Power is on.ױCheck the
normal startup.ױEnd the service.
2. Wire reassembling: If
there is a fault in the
connection of the wires of the compressor
ױPower is on.ױCheck the normal startup. 
ױEnd the service.
3. Compressor replacement: Serious abnorma
l
noise (Metallic scraping or grinding noise),
serious vibration
No
Check the compressor
and the state
of the compressor wire assembling.
1. Do the inter-phase resistance values of
the compressor coincide?
(U ׳ V, U ׳ W, V ׳ W)
2. Are the wires on the co
mpressor correctly connected?
(Non-connection, wrong connection)
3. Is there abnormal noise
in the rotation of the compressor?
Replace the compressor.
No
s the resistance between
the compressor body and the chassis
Mega ?
Yes
Continued