Troubleshooting
4-3
The procedure of setting option(Cont.)
Steps Remote control display
7
Set the SEG9 and SEG10 values:
a Set the SEG9 value by pressing the
(Low Fan) button repeatedly until the
value you want to set appears on the remote control display.
b Set the SEG10 value by pressing the
(High Fan) button repeatedly until the
value you want to set appears on the remote control display.
When you press the (Low Fan) or (High Fan) button, values appear in the
following order:
SEG 9
SEG 10
8
Press the (Mode) button. Heat and On appear on the remote control display.
9
Set the SEG11 and SEG12 values:
a
Set the SEG11 value by pressing the (Low Fan) button repeatedly until
the value you want to set appears on the remote control display.
b
Set the SEG12 value by pressing the (High Fan) button repeatedly until
the value you want to set appears on the remote control display.
When you press the (Low Fan) or (High Fan) button, values appear in the
following order:
SEG 11
SEG 12
10
Press the (Mode) button. Auto and Off appear on the remote control display.
11
Set the SEG14 and SEG15 values:
a Set the SEG14 value by pressing the
(Low Fan) button repeatedly until
the value you want to set appears on the remote control display.
b Set the SEG15 value by pressing the (High Fan) button repeatedly until the
value you want to set appears on the remote control display.
When you press the (Low Fan) or (High Fan) button, values appear in
the following order:
SEG 14
SEG 15
To Next Page
Loading...
