Troubleshooting
4-6
Step 4
Save the option values into the indoor unit
Point the remote control to the remote control sensoron the indoor unit and then press the (Power)button on the remote control. Make
sure that this command is received by the indoor unit; if it is notreceived, press the
(Power) button again.
Step 5
Check whether the air conditioner operates in accordance with the option values you have set
1. Reset the indoor unit by disconnecting and then reconnecting the power cable of the indoor unit or by pressing the RESET button on the
outdoor unit.
2. Remove the batteries from the remote control,insert them again, and then press the
(Power) button on the remote control.
Step 3
Check the option you have set
Check whether the option values that you have set are correct by pressing the (Mode) button repeatedly
[ SEG2, SEG3 ] [ SEG4, SEG5 ] [ SEG6, SEG8 ]
[ SEG11, SEG12 ]
[ SEG9, SEG10 ]
[ SEG14, SEG15 ] [ SEG16, SEG17 ] [ SEG18, SEG20 ]
[ SEG21, SEG22 ] [ SEG23, SEG24 ]
The procedure of setting option(Cont.)
To Next Page
Loading...
