Samsung AE090JXYDEH/EU User Manual

35
Commissioning & Maintenance Sheet
You will need a thermometer and a pen to complete this form:
TheUnit
Model Number From outdoor unit right hand side
Serial Number From outdoor unit right hand side
Ambient Air Temp. Measure this in the garden
Has the filter been cleaned?
Glycol Concentration % Measure this
Has the coil been cleaned?
Has the unit been polished?
InHeatingMode
Water Flow Temp. From remote controller
Water Return Temp. Measure this
Flow Rate ( l/min ) From the flow meter
Temp of air at the back of unit From remote controller
Flow Rate ( l/min ) when all rads
& UFH manifolds are closed
From flow meter
Cylinder
Cylinder model & serial number
Cylinder water temp at start up Press view button on rc
Cylinder water temp after 30mins Press view button on rc
Water flow temp From remote controller
Water return temp Measure this
Flow Rate ( l/min) From flow meter
Immersion heater current Press immersion button on rc
Immersion heater cutout setting Remove cover and adjust to 70°C
CommissioningDatanotrequiredatmaintenance
Where was the unit purchased
Date installed
Date delivered ( Proof of delivery required) Warranty Starts from this date
Date commissioned
Samsung approved installer?
Would you like to be an
approved installer?
Warranty Years Required 3 / 5 / 7 Years
Installation Address
AbouttheEngineer
Engineers Name
Company
Address
Engineers Telephone Number
Email Address
Signature of Engineer
Date
IacceptthetermsoftheSamsungwarrantyandconrmthesystemhasbeenregisteredwithin30daysofdelivery.
Ialsoincludeacopyofthedeliverynote.
Signed
Name
Date

Samsung AE090JXYDEH/EU Specifications

General

Brand	Samsung
Model	AE090JXYDEH/EU
Category	Heat Pump
Language	English