To Next PageTo Next PageHow to fix indoor unit communication error on Samsung Heating System?
To address an indoor unit communication error in your Samsung Heating System: * Check the communication cable of the indoor unit. * Check the DC output voltage at the communication terminal.
What to do if there is a communication error between the remote controller and the Hydro unit in my Samsung AE200RNWMEG Heat Pump?
If your Samsung Heat Pump displays a communication error between the remote controller and the Hydro unit, the suggested solution is to change parts.
How to fix [Inverter] compressor startup error in Samsung Heating System?
If you're experiencing a compressor startup error on your Samsung Heating System, check the compressor connection status. Also, check the resistance between different phases of the compressor.
How to troubleshoot outdoor fan 1 error on Samsung Heating System?
If your Samsung Heating System is showing an outdoor fan 1 error, you should check the input power connection status. Verify the connection status between the motor and outdoor unit PCB. Also, inspect the indoor/outdoor fuse.
How to fix [Inverter] total current error/ PFC over current error in Samsung Heating System?
If your Samsung Heating System is showing an inverter total current error or PFC over current error, begin by checking the input power. Next, verify the coolant charging status. Finally, ensure that the outdoor fan is operating normally.
What to do if a gas leak error is detected in Samsung Heating System?
If your Samsung Heating System indicates a gas leak error, you should check the coolant charging status. Also, examine the indoor EVA sensor. Ensure the outdoor unit service valve is open and verify that the indoor/outdoor installation pipe and wiring are correctly installed.
What to do if [Inverter] IPM over current error occurs in Samsung Heating System?
If you are encountering an IPM over current error on your Samsung Heating System, verify the coolant charging status. Also, check the compressor connection and ensure it's operating normally. Inspect for any obstructions around the indoor and outdoor units. Confirm that the outdoor unit service valve is open and that the indoor/outdoor installation pipe and wiring are correctly installed.
What to do if my Samsung Heat Pump shows a short- or open-circuit error for the Zone 2 indoor unit room temperature sensor?
If your Samsung Heat Pump displays a short- or open-circuit error of the room temperature sensor of the Zone 2 indoor unit (detected only when the room thermostat is used), the suggested solution is to change parts.
What to do if my Samsung Heat Pump shows a short- or open-circuit error for the Zone 1 indoor unit room temperature sensor?
If your Samsung Heat Pump displays a short- or open-circuit error of the room temperature sensor of the Zone 1 indoor unit (detected only when the room thermostat is used), the suggested solution is to change parts.
What does a low flow rate error mean on my Samsung AE200RNWMEG, and how do I fix it?
If your Samsung Heat Pump displays a low flow rate error, it indicates that there is not enough water flow. The suggested action is to turn the water pump ON.
Guidance on using standard parts, ensuring firm connections, and general repair practices.
General safety advice including avoiding wet hands, damaged cords, and proper grounding.
Safety measures for handling refrigerants, including harm to humans and containers.
Procedures for safe brazing, clearing materials, and using nitrogen gas.
Lists error modes, symptoms, measures, and error types for wired remote controllers.
Guides on diagnosing issues based on symptoms like communication errors.
Troubleshooting steps for specific errors related to EEPROM, water pump, and flow sensors.
Further symptom-based troubleshooting for communication, sensor, fan, and compressor errors.
General