Samsung AM200FXWANR - 8 Key Options; List of Field Setting Items

Samsung Electronics 260
Key Options
8-2 List of Field Setting Items
No Optional item Purpose
00
Emergency operation for
compressor malfunction
To exclude the faulty compressor from the system. (emergency use only)
01 Cooling
capacity correction
By this option system cooling capacity can be increased or decreased as
evaporator’s temperature will be colder or hotter than default.
02 Capacity correction for heating
By this option system heating capacity can be increased or decreased as
evaporator’s temperature will be colder or hotter
than default.
03 Current restriction rate
To control the power consumption of the system for the building man-
agement for peak control.
04 Oil collection
interval To shorten the Oil collection interval by 1/2 (Service use only)
05 Temperature to trigger defrost operation To secure clean defrost in harsh condition.
(Air-cooled type only)
06 Fan speed correction
Increase maximum fan rpm range to secure enough airflow when dis-
charge guide duct for outdoor unit
is adapted. (Air-cooled type only)
07 Silent mode for night-time
Limit Maximum fan rpm & compressor frequency to reduce noise during
the night time ױ M
ax 15dB reduction.
* Only for cooling & Main cooling operation. (Air-cooled type only)
08 High-head condition setting
To optimize the refrigerant control of the
system according to the installa-
tion condition.
09 Long-piping condition setting To optimize the system control according to the installation condition.
10 Energy savin
g setting
To save energy in heating mode by controlling the target high pressure in
heating.
11 Rotation defrost
Continuous heating operation during defrost in modu
le installation.
(HR model only)
During the R-defrost Heating Indoor unit’s airflow will be set as low.
(Air-cooled type only)
12
Expand operational temperat
ure range
for cooling
To expand cooling operation range up to -15ఁ .
(HR model only, Default : -5ఁ ) (Air-cooled type only)
13 Channel address To recog
nize each outdoor system when using centralized controller.
14 Snow accumulation prevention
To prevent snow is accumulating on the outdoor unit fan dischar
ge guide.
(Air-cooled type only)
17 Speed operation To increase cooling or heating speed.
18 Max. capacity restriction
Restrict excessive capacity increase wh
en operating indoor units with
small capacity.
19 Gas leak Pump down If the gas leak occurred it should be entered in the pump down operation.
20 Circulation
fluid flow setting Circulation fluid type setting.
21 Low ambient kit
Setting of the low ambient kit use for cooling operatin in low ambient
te
mperature condition. (Air-cooled type only)
22 Emergency operatin
When set, emergency operation is possible even if an indoor communica-
tion error o
ccurs.