Samsung Electronics 44
Disassembly and Reassembly
No. Work Procedure Remark
1
Be sure to power OFF the circuit breaker before discon-
necting the power supply.
Unfasten the two screws on the protective cover of the
power connection box and remove the protective cover.
Remove the (transparent) cover on the terminal block.
Disconnect the power cables on the input side of
the terminal block.
The power cables are fixed with screws on the terminal
block. Use a spanner or hex wrench to disconnect the
power cables. Use insulation tape to wrap each power
cable before storage to prevent the cables from coming
into contact with each other.
AM080/100/120FXWA***
AM200/300*XWA***
AM072/096/120HXWA***
AM192/240*XWA***
Terminal block cover
Power terminal block
on the input side
3-2 Disassembly and Reassembly (cont.)
3-2-3 Disconnecting the Power Supply
To Next Page
Loading...