Disassembly and Reassembly
Samsung Electronics 47
No. Work Procedure Remark
1
- Use a torch to heat and separate the three welded joints
connecting the compressor to the pipes.
- Unfasten the four nuts on the compressor.
- Separate the compressor from the device while leaning
the compressor towards you.
2) Removing the right compressor
- Follow the same steps used when removing the right
compressor.
- Note that the shapes of the pipes are different from the
right compressor, as shown in the image.
Pay attention when separating the welded joints.
ఐ When reassembling it after inspection, be sure to tight-
ly fasten the screws.
∙ Check the cable connection for the U, V and W phases.
∙ A loosely fastened screw may cause a fire.
Be sure to tightly fasten the screws.
3-2 Disassembly and Reassembly (cont.)
3-2-4 Removal Instructions for Compressor
To Next Page
Loading...