Accessories
PREPARING FOR INSTALLATION
The following accessories are supplied with the air conditioner:
The number of each accessory is indicated in parentheses.
The flare nuts are attached to the end of each pipe of an evaporator or a service port.
Use the nuts when connecting the pipes.
The (2)(3)4-wire assembly cable is optional. If it is not supplied, use the standard cable.
The drain plug and rubber leg are only included when the air conditioner is supplied
without the assembly pipe as seen in the picture below.
If these accessories are supplied, they will be in the accessory box.
Accessories in the Outdoor Unit Case
Accessories in the Indoor Unit Case
Installation Plate (1) Remote Control (1)
Batteries for
Remote Control (2)
User’s Manual (1) Installation Manual (1)
The following connection accessories are optional. If they are not supplied, you should obtain them before
installing the air conditioner.
4-wire
Assembly Cable (1)
Drain Plug (1) Rubber Leg (4)
Assembly Pipe,
Ø6.35mm (1)
Assembly Pipe,
Ø12.70mm (1)
Assembly Pipe,
Ø15.88mm (1)
PE T3 Foam Tube
Insulation (1)
Vinyl Tape (2) Drain Plug (1)
Rubber Leg (4) Pipe Clamps B (3) Cement Nail (6) M4 x 16
Tapped Screws (6)
Drain Hose,
length 2m (1)
Putty 100g (1)
Remote Control (1)
F
/
NS
VB
Assembly Pipe,
Ø9.52mm (1)
Pipe Clamps A (3)
18
24
3-wire
Assembly Cable (1)
2-wire
Assembly Cable (1)
3-wire
Power Cable (1)
09/12
18/24
18/24
18/24
09/12
To Next Page
Loading...
