Reference Sheet
Samsung Electronics13-5
■ The indoor unit option switch setup
K1 K2 K3 K4
K5 K6 K7 K8
K9
K10
K11
K12
FUNCTION SWITCH NO. SWITCH ON SWITCH OFF
WIRED REMOTE CONTROL K1
K2
K3
K4
K5
NOT USED
NOT USED
INITIAL SETUP RPM
NOT USED
NOT USED
1,000 HOURS
NOT USED
NOT USED
FIXED TO 80
0 ~ 15 GROUP
USED
USED
RPM
COMPENSATION
USED
USED
2,000 HOURS
USED
USED
0 OR 80
16 ~ 31 GROUP
CENTRALIZED CONTROLLER
INDOOR UNIT RPM COMPENSATION
USED/NOT USED THE DRAIN PUMP
(RELATED TO THE INDOOR UNIT ONLY
INSTALLS THE DRAIN PUMP/AS OPTION)
FILTER EXCHANGE(CLEANING) TIME
K6
K7
K8
K9
K10
HOT WATER HEATER
ELECTRIC HEATER
INDOOR UNIT EEV OPEN AT HEATING
NOT USED
USED
K11EXTERNAL CONTROL SIGNAL
-
-
K12-
INTERFACE MODULE GROUP SETTING FOR
CENTRALIZED CONTROL
HEATING ROOM TEMP. COMPENSATION
1-WAY, RAC, DUCT : USED( 5˚)/NOT USED(2˚C)
4-WAY : USED(2˚C)/NOT USED(5˚C)
• Every switch is set ON at factory setting.
• It may be occurred the indoor unit operation error if the switch is set at will on installation.
• Be sure to adjust the setup of switch ON/OFF to its function.
• Confirm usable switch label each indoor unit.
24103A(1)_2 12/23/05 12:57 PM Page 12-14
To Next Page